|
contents | products | |||||||||
| New Ultimate Control laminating adhesive National Adhesives has introduced a new high performance resin adhesive product line that can help laminators attain high line speeds and reduce adhesive usage and production costs for point-of-purchase and other types of laminating applications. National's 32-541A resin UC adhesive provides accurate, consistent and optimal adhesive application control required for lamination application and retrofit equipment. It provides a balance of tack, open time, and set speed and reduces moisture transfer into the sheet. The high hold-out properties of 32-541A resin UC adhesive enable operators to meter glue-line width, reducing waste adhesive drip from flute tips. Glue line thickness can be metered down, and adhesion and set time can be controlled on an application-specific basis. Formulated to work on all types of laminating equipment, 32-541A resin UC adheres to a wide range of substrates and enables operators to run lines without concern for adhesive changeover and the associated downtime. The adhesive is less reliant on the substrate for absorption and drying than other adhesives. As a result, it runs as effectively on heavy, coated, or varnished sheets as it does on lighter, uncoated sheets. The adhesive also runs without slinging, eliminating downtime required for clean up. The Aerobond foaming system injects the adhesive with air, which is then carefully blended to create consistently sized, microscopic bubbles within the adhesive. This process significantly reduces adhesive density, weight and water content, resulting in faster drying time, reduced surface imperfections and less adhesive required for proper adhesion. write your comments about the article :: © 2007 Construction News :: home page |