|
contents | news | |||||||||
| New Snap-Line of handles install 'in a snap' without screws or tools  DIRAK, a global innovator in latches, locks and hinges, has introduced a new line of handles that is unique in the marketplace because they are so simple to install. A moderate pressing motion is all that is required to install the handle in place on a prepared panel. Marketed under the SNAP-LINE brand, these handles require no screws for installation. It eliminates the risk of screws that can loosen over time and fall out onto sensitive equipment where they can cause damage. SNAP-LINE handles hold securely in place, even in severe vibration environments. Additionally, the strength of the product is never compromised. Unlike plastic "clip-in" models on the market, SNAP-LINE handles are made of zinc die-cast, including the actual D-SNAP "snap-in" mechanism.There are many aesthetic designs and sizes to choose from, and the handles are even ergonomically designed so that they can be easily used even with gloved hands. DIRAK can also customize designs for your unique application on doors and panels of all sizes. There are even several types of SNAP-Line handles including: grab handles in several different sizes, pull handles and concealed handles. SNAP-LINE handles enable manufacturers to save time and effort in final assembly. Panel preparation is a simple rectangular cut-out. Traditionally, installing a handle involves several steps: aligning the hardware, fitting washers and nuts, and tightening the screws. Installation of a SNAP-LINE handle from start to finish, takes about as much time as merely aligning a part - the first step of traditional assembly. No tools are required. The D-SNAP housing holds a spring-loaded set of wings designed to snap into position to hold the handle firmly in the panel. To allow for easy replacement and for maintenance of associated areas, the D-SNAP mechanism can be retracted using a tool, easily allowing the hardware to slide back out from the panel opening. write your comments about the article :: © 2005 Construction News :: home page |