|
contents | news | |||||||||
| New one-piece Angler™ Pipe and Conduit Clamp  The new one-piece Angler™ Pipe and Conduit Clamp from Thomas & Betts is quick and easy to install. Just snap apart the two halves of the strut strap, fit to the pipe or conduit, slide the pre-threaded bolt through the innovative keyhole-shaped opening in the strap and tighten. An extruded, tapped thread form hold is securely, offering the loading performance of a hex nut but with easier handling. The signature bent tab design of the Angler Pipe and Conduit Clamp readily allows the clamp halves to be assembled and the bolt to extend up at a 30-degree angle, providing the installer immediate access to the bolt with a screwdriver or power tool - even if the clamps are installed side by side.A difficult angle can make it time-consuming to fit a clamp to a pipe or conduit. The bent tab design allows the bolt to extend up at a 30° angle, providing easy access to the bolt even when clamps are installed side by side. Simply slide the pre-threaded bolt through the keyhole-shaped opening and tighten. And no need to unscrew the bolt before installing! write your comments about the article :: © 2005 Construction News :: home page |